MTX-4 RH Rear Brace Aluminium MTX4-08/TI for chassis tuning by 3Racing  [MTX4-08/TI]

Mugen Seiki MTX4 Aluminium Rear Brace RH For Mugen MTX-4 - Titanium Color - 3RACING MTX4-08/TI
Price:
USD$9.40
Brand:
3Racing
Model:
MTX4-08/TI
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

RH aluminium brace designed for MTX-4 rear bulkhead

Manufactured as a right-hand aluminium rear brace compatible with the Mugen MTX-4 rear assembly, this 3Racing item is designated MTX4-08/TI and features a titanium-look finish. Its purpose is to provide a firmer rear bulkhead connection for racers and tuners seeking predictable changes to chassis stiffness.

The component uses existing MTX-4 rear mount points and replaces the factory RH brace without chassis alteration. By increasing rigidity at the rear bulkhead, the brace helps control transient load transfer and refines rear traction response, allowing setup changes to address understeer or oversteer tendencies.

For installation inspect fastener condition and torque consistently to avoid misalignment. Use standard hex drivers sized to the chassis hardware and check body and shock tower clearances during trial fitting to ensure repeatable geometry under load.

What effect does a stiffer rear brace have on transient behaviour?

A stiffer rear bulkhead reduces flex and yields crisper rear response during load changes, which can improve corner exit traction when used alongside correct damping settings.

Are there recommended companion setup changes?

Consider softer rear damping or slightly more rear toe-in to offset increased stiffness, and adjust anti-roll bars to fine-tune balance depending on surface grip.

What inspection steps should be taken after fitting?

Verify fastener torque after initial runs, check for any clearance issues under full suspension travel, and re-evaluate corner weights and alignment as required.