Precision wide front swing roller plate M4WD-50/SG for Mini 4WD by 3Racing  [M4WD-50/SG]

Tamiya Mini 4WD Sliver Carbon Wide Front Swing Roller Plate - 3RACING M4WD-50/SG
Price:
USD$11.30
Brand:
3Racing
Model:
M4WD-50/SG
Condition:
Brand New
Write a review

Precision silver carbon wide swing roller plate M4WD-50/SG for Mini 4WD

Aftermarket front swing roller plate engineered for Mini 4WD applications where wide front stay geometry and secure swing mounting are required. The component carries a silver carbon finish and is intended for experienced tuners and collectors who prioritise fit and durability.

The plate retains a compact frontal profile while preserving mounting points for standard swing rollers, with the technical emphasis on reliable alignment, clean roller routing, and consistent fitment across common Mini 4WD stays. This is a component-level upgrade focused on assembly quality rather than performance tuning guidance.

Technical fit notes: verify fastener engagement lengths and spacer stack when fitting to reinforced or multi-layer stays. Ensure roller shafts and bearings run without axial or lateral binding through the swing travel. For show-oriented builds inspect the surface during assembly to avoid blemishes to the silver carbon finish.

How do I confirm hole alignment with my stay?

Measure the plate hole centres and compare to your stay pattern; use a trial fit with temporary fasteners to confirm alignment before final tightening.

What spacer strategy ensures consistent swing travel?

Use spacers that match shaft diameter and subtract any stay thickness to avoid preload on bearings; nylon spacers can protect plated finishes while maintaining parallel swing action.

Are there recommended inspections after initial runs?

After the first test runs check bearing seating, fastener torque, and any abrasion at contact points; re-torque hardware after initial bedding in.

What fastener types minimise wear on stays?

Short machine screws with properly sized washers or threaded inserts provide repeatable clamping while reducing point stress on thin or reinforced stays.

Best practice for preserving the silver finish?

Handle with lint-free gloves during final assembly, avoid solvent contact, and inspect mounting edges after any running to catch early wear.