SAK-D6816/PU Rear Upright for Auper D6 (Purple) by 3Racing  [SAK-D6816/PU]

Price:
USD$18.80
Brand:
3Racing
Model:
SAK-D6816/PU
Condition:
Brand New
Write a review

Aftermarket rear upright for Auper D6

This aluminium rear upright is supplied as a direct replacement for the Auper D6 RC chassis. It functions as the mounting point for the rear wheel hub and links to the suspension carrier, retaining original mounting positions while providing a metal alternative to the factory composite piece.

Suitable for hobbyists and tuners working on Auper D6 touring cars, the upright helps maintain consistent rear suspension geometry. Install it to replace damaged components or to gain reduced flex in hub areas that affect toe and camber response.

Fitting is performed in the same order as the stock part: remove the wheel and hub assembly, unbolt the upright from the hub carrier and suspension links, fit the replacement, and reassemble while confirming bearing seating and alignment. Standard RC maintenance tools are sufficient; check screw torque and clearances prior to use.

Specifications

  • Item: Rear upright
  • Material: Aluminum
  • Model Number: SAK-D6816/PU
  • Color: Purple anodized
  • Compatibility: Auper D6

As an aftermarket aluminium replacement for the Auper D6 rear upright, this part is intended to restore reliable rear hub geometry for maintenance and tuning tasks.

How do I confirm fitment before full installation?

Trial-fit the upright without final torque to ensure mounting holes align and bearings seat correctly. Check that screw lengths do not protrude or bottom out against the aluminium housing.

What should I inspect after a crash?

Inspect the anodize for chips and the upright for bends or cracks. Replace any bearings or hardware that show damage and verify that geometry has not shifted before returning the car to service.

Can this upright be used to tune rear feel?

Using a stiffer aluminium upright can change the mechanical feedback and make geometry more consistent, which is useful when refining toe and camber for track conditions.

Any routine maintenance recommended?

Regularly clean the part, check for loose screws, and inspect for finish damage. Replace any worn bearings and ensure hardware is torqued correctly to prevent thread wear in the aluminium.