3Racing SAK-F81 Graphite Front Shock Tower - Racing Setup Component  [SAK-F81]

SAKURA FF EVO Front Graphite Shock Tower For KIT-FFEVO - 3Racing SAK-F81
Price:
USD$10.10
Brand:
3Racing
Model:
SAK-F81
Condition:
Brand New
Write a review

Precision Front Shock Tower for Competitive Setup

The 3Racing SAK-F81 Graphite Front Shock Tower is crafted to support fine tuning of the SAKURA FF EVO front end. Manufactured from performance-grade graphite, the tower delivers a stiff yet lightweight mounting platform that helps maintain consistent shock geometry under load. It is compatible with the KIT-FFEVO mounting pattern for direct fitment.

Technical Advantages for Tuning

Graphite lowers mass at the front of the car while retaining lateral rigidity, which assists drivers in refining turn in and mid corner behaviour. The material supports repeatable mounting points for reliable setup comparisons when adjusting springs, dampers and anti-roll characteristics.

Installation and Setup Considerations

Install the SAK-F81 using the OEM mounting locations to preserve baseline geometry. After fitting, verify shock travel and pivot alignment and recheck fastener torque as part of your setup routine. This allows precise comparison of handling changes during tuning sessions.

Can this be used to test different shock rates?

Yes, the consistent mounting and reduced mass make the SAK-F81 useful when evaluating changes to spring rates and damper tuning during setup work.

Should I retorque hardware after first run?

It is good practice to recheck and retorque all mounting screws after initial track sessions to ensure no settling occurs and geometry remains true.

Does graphite affect shock response consistency?

The material supports consistent shock alignment which can improve damping repeatability, but final response depends on the full shock and spring setup.