TA05 Front Suspension Mount FF 3 Degree Aluminium TA05-10/3/LB by 3Racing  [TA05-10/3/LB]

Tamiya TA05 /TA05-R Aluminium Front Suspension Mount ( FF/3 Degree ) - Light Blue Color - 3Racing TA05-10/3/LB
Price:
USD$7.50
Brand:
3Racing
Model:
TA05-10/3/LB
Condition:
Brand New
Write a review

Technical front suspension mount for TA05 chassis

The TA05-10/3/LB is a machined aluminium front suspension mount engineered for direct fitment to Tamiya TA05 and TA05-R platforms. Designed to replace the original plastic front mounting point, this component preserves the FF 3 degree geometry while providing a rigid, anodized light blue mounting surface suitable for precise setup work.

Compatibility is restricted to TA05-family chassis. Installation follows the stock suspension geometry and uses existing attachment points; standard hex drivers and basic hobby tools are required. No additional brackets or specialised fasteners are normally necessary, but inspect and renew worn screw hardware to ensure correct clamping torque and alignment.

From a setup and tuning viewpoint the aluminium mount reduces attachment flex and helps maintain repeatable front-end geometry under corner loads. This stability improves the fidelity of steering feedback and enables clearer comparison when adjusting damper valving, spring rates, or toe settings.

What exact chassis is this compatible with?

Compatible only with the Tamiya TA05 family, including TA05 and TA05-R platforms as the mount uses their original attachment geometry.

Are torque settings different from the stock mount?

Use the same torque approach as the OEM mount but verify even clamping to avoid local distortion; replace any degraded screws or ball studs before final torque-up.

How does this part assist precise setup work?

The rigid aluminium mounting surface reduces variability at the front pivot, allowing more consistent measurement of steering response and roll changes when tuning suspension parameters.