TA05 Race-Oriented Swing Shaft TA05-IF02/HD for Tamiya TA05 Platforms by 3Racing  [TA05-IF02/HD]

Tamiya TA05-IFS /TA05-R Swing Shaft - Heavy Duty - 3Racing TA05-IF02/HD
Price:
USD$12.90
Brand:
3Racing
Model:
TA05-IF02/HD
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Race-oriented swing shaft for TA05 setups

This swing shaft is a direct-replacement component tailored for Tamiya TA05-IFS and TA05-R chassis. It transmits rotation from the gearbox to the hubs and is intended to withstand heavier loads encountered in competitive running without the failure modes seen on standard shafts.

Compatibility is restricted to TA05-IFS and TA05-R configurations; confirm chassis ID before fitting. The shaft is supplied for direct swap installation and should be fitted following standard TA05 driveline procedures, with careful inspection of bearing fit and hub mating faces to preserve true alignment.

From a setup and tuning viewpoint, the TA05-IF02/HD is specified to improve driveline stability under load rather than to alter suspension geometry. The result is reduced drivetrain compliance and a more repeatable torque transfer during aggressive throttle application and technical track sequences.

Is the TA05-IF02/HD intended for competitive use?

Yes. The part is aimed at drivers wanting improved drivetrain reliability and more consistent torque delivery in race conditions on TA05-IFS and TA05-R platforms.

Any setup advice for optimised performance?

Fit the shaft on a clean bench, verify bearing preload and hub alignment, and replace any compromised bearings or mating hardware to maintain precise driveline geometry.

Will this reduce drivetrain compliance under load?

The design targets reduced driveline compliance and more repeatable torque transfer, which helps stability during corner exit and heavy acceleration.