TA05 Racing Front Solid Axle Aluminium upgrade TA05-20/LB by 3Racing  [TA05-20/LB]

Tamiya TA05 /TA05-IFS /TA05-R Aluminium Front Solid Axle - 3Racing TA05-20/LB
Price:
USD$14.90
Brand:
3Racing
Model:
TA05-20/LB
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Competition-oriented aluminium front solid axle for TA05

This aluminium front solid axle is produced as a direct-fit upgrade for Tamiya TA05, TA05-IFS and TA05-R chassis, intended for race and high-performance practice use. As a metal replacement it raises front torsional rigidity compared with the stock plastic component, giving more immediate feedback under load for 1/10 touring car setups.

Installation uses the chassis original TA05 mounting points and hardware and is performed at chassis level. The increased rigidity sharpens initial steering response and alters dynamic weight transfer into the front suspension during cornering. Drivers should treat the axle as a tuning tool in the overall setup package, together with spring rates, roll bars and tyre selection to dial in balance for competition conditions.

Recommended workflow: install the axle, perform controlled test runs, log handling changes and then make incremental suspension and tyre adjustments. Inspect mounting fasteners and contact surfaces after heavy sessions to ensure consistent performance. This part is specified as an aluminium front solid axle for track-oriented tuning and race practise.

What are the expected on-track benefits?

Primary benefits are increased front torsional rigidity and sharper steering onset, which can improve lap consistency when combined with matched spring and anti-roll bar settings.

How should I tune after fitting for competition?

Use a stepwise approach: baseline runs, adjust front spring rate or soften slightly if the car becomes twitchy, then fine tune anti-roll bars and tyre pressures to restore desired balance.

Any prep or inspection advice before racing?

Verify all mounting screws are torqued to spec, check that mounting faces are flat and free of debris, and inspect for any signs of impact damage after practice or qualifying sessions.