TA05-IF14/0/LB Rear Hub Carrier 0 Degree for TA05-IFS TRF-416 by 3Racing  [TA05-IF14/0/LB]

Tamiya TA05-IFS /TRF-416 Aluminum Rear Hub Carrier - 0 Degree - 3Racing TA05-IF14/0/LB
Price:
USD$12.50
Brand:
3Racing
Model:
TA05-IF14/0/LB
Condition:
Brand New
1 Reviews
Write a review

Rear hub carrier technical overview for TA05-IFS/TRF-416

This aluminium rear hub carrier is specified for use with Tamiya TA05-IFS and TRF-416 rear upright assemblies and is identified by 3Racing part number TA05-IF14/0/LB. It provides a rigid hub mounting that supports consistent rear geometry during on-road tuning.

The 0 degree designation denotes the carrier's neutral caster and roll-center relationship. Replacing the carrier alters load paths at the rear hub and can be used to refine traction and transient response without changing major suspension components.

Installation involves a direct replacement of the original carrier: remove the existing unit from the upright, install this aluminium carrier in the same orientation and secure with original fasteners. Post-installation checks should include bearing seating, wheel spin clearance and rear toe verification.

Use this component to achieve repeatable rear-end behaviour during setup sessions and to make controlled adjustments to rear traction characteristics while preserving the platform's baseline suspension geometry.

 

Product Reviews
1 Reviews
rating
fast delivery i will shop here for tamiya 416 parts again i wish you sold all of the stock parts aswell like gears and ball joints and drive shafts as you only sell hop up parts for the tamiya 416 could you please advise me to were i could find such part

What is the intended function of a 0 degree carrier?

A 0 degree carrier fixes the hub roll-center and caster relation in a neutral orientation, allowing tuners to assess other variables without introducing additional roll-center offset from the carrier itself.

Which assembly checks are recommended after fitting?

Verify correct bearing seating, confirm there is no binding in the hub, and measure rear toe to ensure geometry remains within expected tolerances for on-road operation.

Is this carrier compatible with modified uprights?

Compatibility depends on upright machining and hole pattern; this part is intended for standard TA05-IFS and TRF-416 geometries, so confirm that any modified uprights match the original mounting features before installation.