TA05-IFS Precision Bearing Service Kit BS-M05/V1 by 3Racing  [BS-M05/V1]

Tamiya TA05-IFS Option Ball Bearing Set - 3RACING BS-M05/V1
Price:
USD$12.70
Brand:
3Racing
Model:
BS-M05/V1
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical service bearings for TA05-IFS

This bearing kit is intended for the Tamiya TA05-IFS platform and is supplied as BS-M05/V1. It provides the bearings required at standard rotating interfaces to support routine maintenance and measured tuning of drivetrain components.

Fit bearings with attention to concentric seating and contamination control. Ensure bores are clean, press bearings squarely on the outer race and confirm shafts rotate freely with minimal axial play. Typical installation points include wheel hubs, differential carriers and other rotating mounts on the TA05-IFS chassis.

Use the set for preventative maintenance and incremental performance improvements. Monitor for increased runout, roughness or axial looseness and replace bearings that exceed acceptable tolerances to protect precision components.

What inspection checks are recommended after installation?

Verify radial and axial play by rotating shafts by hand, listen for roughness and check for consistent bearing runout. Recheck seating after initial test runs.

How should bearings be pressed to avoid damage?

Use a press or driver that applies force to the outer race only; avoid impacting the inner race or shaft to prevent brinelling and premature failure.

Recommended maintenance intervals for typical club use?

Inspect bearings during routine strip-downs or after exposure to water or heavy dirt. Replace any bearing showing rough rotation or increased play to maintain drivetrain accuracy.