TA05-IFS Race-Focused Aluminium Front Bulkhead TA05-IF08/LB by 3Racing  [TA05-IF08/LB]

Tamiya TA05-IFS Aluminium Front Bulkhead - Light Blue Color - 3RACING TA05-IF08/LB
Price:
USD$20.00
Brand:
3Racing
Model:
TA05-IF08/LB
Condition:
Brand New
Write a review

Race-oriented aluminium front bulkhead for TA05-IFS

This front bulkhead is machined from aluminium with a light blue finish and serves as the structural mounting interface for the Tamiya TA05-IFS chassis. It secures steering and suspension pick-up points to the chassis plate while prioritising accurate, repeatable locations.

Designed with competitive setup work in mind, the bulkhead reduces front-end compliance that can alter suspension angles under load. That stability allows more predictable handling and makes fine tuning adjustments easier to evaluate on the lap.

Installation follows standard TA05-IFS procedures: remove the OEM bulkhead, transfer appropriate bearings and hardware, and attach the replacement using the chassis' factory mounting holes. Check steering linkage alignment and suspension articulation after fitment to ensure correct operation.

Specifications

  • Item Aluminium Front Bulkhead
  • Material Aluminium
  • Model Number TA05-IF08/LB
  • Compatibility TA05-IFS

For racers and tuners seeking a direct, light blue aluminium front mount that enhances mounting repeatability and reduces front-end compliance, this 3Racing bulkhead is a focused upgrade for TA05-IFS setups.

What is the expected impact on chassis compliance?

The aluminium construction reduces flex at the front mounts, lowering compliance that can shift suspension geometry under load and improving repeatability for setup comparisons.

Are there any recommended checks after fitting?

Verify bearing seating, fastener torque, steering free-play and suspension travel. Re-check wheel alignment after a short test run to confirm settings remain consistent.

Does this require different setup settings?

No radical changes are required; expect improved stability of existing camber and toe settings. Small tuning adjustments will be easier to evaluate due to reduced chassis-induced variation.

Is specialised preparation needed for racing use?

Keep mating surfaces clean, confirm correct fastener torque and inspect for wear between events. These routine checks help maintain the bulkhead's performance during competition.