TAMIYA F103RM Friction Damper Pole F103RM-13 by 3Racing  [F103RM-13]

Tamiya F103RM Friction Damper Pole - 3RACING F103RM-13
Price:
USD$1.90
Brand:
3Racing
Model:
F103RM-13
Condition:
Brand New
Write a review

Precision friction pole for F103RM chassis

The F103RM-13 pole is supplied as an exact internal replacement for the friction damper used on the TAMIYA F103RM chassis. It is specified to interface cleanly with the damper bore and provide repeatable manual damping adjustments for competitive 1/10 touring setups.

Service procedure: disassemble the friction damper, remove the worn pole, inspect the bore and internal components for wear or contamination, then install the F103RM-13 using the original retainers and fasteners. Use common hobby tools and verify there is no lateral play after assembly.

Performance note: this pole affects the mechanical transfer of friction within the damper, allowing more granular adjustment of rebound and compression feel. Use small incremental changes when tuning to evaluate on-track response.

Maintenance guidance: clean the pole and bore during scheduled damper servicing, monitor for surface scoring, and replace the pole if any roughness or looseness is detected to preserve consistent damping characteristics.

What checks should I perform before fitting the pole?

Inspect the damper bore and seals for contamination or wear, verify screw threads and retainers are sound, and ensure the pole slides freely without side play before final assembly.

Is any bedding-in required after installation?

No formal bedding-in is required; however, confirm smooth operation through a few test runs and recheck for correct seating and absence of binding.

How should I evaluate damping changes on-track?

Make incremental adjustments and judge changes in rebound and compression feel across consistent test laps to determine the best pole setup for your chassis and surface conditions.