Tamiya F104 One-piece Front T-bar 1.8mm F104-08/18/FG by 3Racing  [F104-08/18/FG]

Tamiya F104 One Piece T-Bar 1.8mm - 3RACING F104-08/18/FG
Price:
USD$6.30
Brand:
3Racing
Model:
F104-08/18/FG
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

One-piece T-bar for focused F104 setup

This aftermarket hop-up is specified for the Tamiya F104 chassis under part number F104-08/18/FG. The 1.8mm single-piece T-bar is intended to give racers a repeatable method to increase front torsional stiffness and refine steering response without changing suspension geometry.

Compatibility is targeted at standard Tamiya F104 layouts; confirm mount alignment before fitting. The component replaces the factory T-bar at the original mounting points and alters front load transfer characteristics during cornering and quick direction changes.

Assembly notes: remove the stock T-bar and install this unit with the original hardware and hex drivers. For setup, use incremental on-track tests to quantify steering changes and pair the T-bar selection with small damper or toe adjustments to reach the desired handling balance.

How does 1.8mm compare to thinner options for lap consistency?

A thicker bar reduces transient chassis flex, which can stabilise steering under varying loads and improve repeatability across laps when matched to appropriate damper settings.

Should I alter anti-roll balance after fitting?

Often a small reduction in front roll stiffness or a damper tuning change helps rebalance the car after stiffening the front; test in controlled increments to measure effect.

Is this compatible with common F104 tuning setups?

Yes, it is designed to integrate with typical F104 setups and is useful in both practice and competition environments for drivers seeking crisper steering and reduced front flex.