3RACING 1.8mm T-Bar for Tamiya F104 Racing Setup  [F104-07/18/FG]

Tamiya F104 T-Bar 1.8mm - 3RACING F104-07/18/FG
Price:
USD$3.80
Brand:
3Racing
Model:
F104-07/18/FG
Condition:
Brand New
Write a review

Race focused tuning with the 3RACING 1.8mm T-Bar for Tamiya F104

This 3RACING 1.8mm T-Bar is intended for drivers seeking measurable changes in chassis roll behaviour on the Tamiya F104 platform. It provides a predictable stiffness profile useful for fine tuning front end balance.

Engineering and fitment details

Manufactured to suit F104 mounting geometry, the T-Bar integrates without modification and keeps suspension kinematics intact. The 1.8mm thickness is chosen to give a specific roll rate that complements common damper and spring choices used in racing setups.

Installation and setup workflow

Install with standard RC hand tools and verify alignment under static load. After fitting, test with incremental damper and toe adjustments to identify the optimal trade off between turn in and mid corner stability.

Competitive benefits and tuning range

For racers, the bar offers a low mass, low complexity way to tune chassis response. It is suitable for iterative setup work where controlled changes are preferred over wholesale component swaps.

How does the 1.8mm T-Bar affect front roll stiffness numerically?

The 1.8mm gauge increases front roll stiffness modestly compared to softer bars, tightening roll angle while still allowing progressive compliance. Use telemetry or feel to compare lap times before and after.

What baseline setup should I start from after fitting this bar?

Begin with your established damper settings and make small spring or rebound changes. Check front toe and caster to match the new roll behaviour and validate with short runs.

Is there any recommended maintenance for this part between events?

Regularly inspect mounting hardware and the bar profile for nicks or bending. Replace fasteners that show wear and keep contact faces clean to preserve consistent performance.