Tamiya FF-03 Competition Rear Shock Tower -15 FF03-15A by 3Racing  [FF03-15A]

Tamiya FF-03 Graphite Rear Shock Tower Replacement -15 - 3RACING FF03-15A
Price:
USD$10.00
Brand:
3Racing
Model:
FF03-15A
Condition:
Brand New
Write a review

Competition rear tower for FF-03

This graphite rear shock tower is engineered for the Tamiya FF-03 rear shock mount as a direct replacement, focusing on tuning rear suspension geometry for racing use. The -15 offset defines a specific rear mounting position that alters shock angle and rear roll centre; the unit is supplied as a single deck for the rear shock assembly.

Installation is intended for technicians familiar with FF-03 maintenance: remove the OEM tower, transfer compatible shocks and hardware, and fasten the replacement using the factory mounting points. Graphite delivers a stiff rear fixing while keeping unsprung mass low at the rear axle.

In setup terms, the -15 tower modifies shock lever arm and attack angle to sharpen transient response and refine rear traction on short-track race layouts. This component is a geometry-focused upgrade to fine tune handling rather than a complete suspension conversion.

What is the main benefit for race setup?

The main benefit is a changed shock geometry that improves rear transient control, allowing drivers to tune turn-in and mid-corner behaviour for competitive lap times.

Should I change spring rates with this tower?

Altering leverage ratio may require spring or damper adjustments; consider slightly firmer damping or spring rates if rear feel becomes too soft after fitting.

Is this suitable for timed short-track events?

Yes, the -15 geometry is often chosen for short-track and technical layouts where quick rear response and controlled traction improve lap consistency.