3RACING FF03-09/WO Graphite Front Bulkhead Stiffener Kit  [FF03-09/WO]

Tamiya FF-03 Graphite Front Bulkhead Stiffener - 3RACING FF03-09/WO
Price:
USD$8.80
Brand:
3Racing
Model:
FF03-09/WO
Condition:
Brand New
Write a review

Race-Focused Front Bulkhead Stiffening for the Tamiya FF-03

The 3RACING graphite front bulkhead stiffener is engineered to increase front chassis rigidity on the Tamiya FF-03, enhancing repeatable steering inputs and predictable mid-corner behaviour. It is intended for drivers refining handling for competitive conditions.

Engineering and Compatibility

Fabricated from high-grade graphite, the stiffener is dimensioned to match the FF-03 bulkhead mounting points and maintain alignment with standard suspension geometry. By limiting front-end flex, the component improves feedback consistency at speed and during rapid load transitions, aiding setup tuning and tyre performance.

Fitment Procedure and Setup Notes

Fitment is performed using standard fasteners and basic hand tools. Apply consistent fastening torque across mounting points to avoid uneven preload. Once installed, evaluate changes to front-end feel and small adjustments to spring rates or toe may be required to optimise lap time performance.

How does this affect chassis tuning for racing?

Increasing front rigidity reduces compliance in the front end, which can sharpen turn-in and improve consistency; expect to fine tune springs and anti-roll settings to rebalance handling.

Is the part suitable for sprint and endurance formats?

Yes, the stiffener benefits both short format sprint racing by improving precision and endurance running by providing stable handling over varying track conditions, provided routine checks are performed.

Any recommended inspection routine?

Inspect mounting hardware for torque retention after races and look for any graphite fibre damage after impacts; replace the stiffener if structural integrity is compromised.