Tamiya FF03 Technical Thrust Bearings M2.6 x 6 - FF03-01B by 3Racing  [FF03-01B]

Tamiya FF03 M2.6 x 6 Thrust Bearing -2pcs -01 - 3RACING FF03-01B
Price:
USD$5.00
Brand:
3Racing
Model:
FF03-01B
Condition:
Brand New
Write a review

Technical replacement pair for FF03 thrust locations

Supplied as a two-piece set, these thrust bearings are intended for the thrust bearing positions used in the Tamiya FF03 chassis. Both bearings are dimensioned M2.6 x 6 to meet the seating and axial control points in the FF03 drivetrain.

Designed for competitive hobbyists, these thrust bearings stabilise axial shaft movement and preserve gear alignment under varied loading. They function as service replacements to restore drivetrain geometry and reduce abnormal wear on mating components.

For installation, verify shaft and bore tolerances match M2.6 x 6, press the bearing squarely into its seat, then measure axial clearance and confirm free rotation across the operating range. Replace in matched pairs where recommended to maintain consistent drivetrain behaviour.

What dimensional checks should I perform?

Measure shaft diameter and housing bore to confirm M2.6 x 6 compatibility, check for concentric seating, and inspect for burrs or wear that could affect axial clearance.

Recommended lubrication approach?

Use a light bearing oil or low-viscosity lubricant compatible with gears to reduce friction without attracting debris; avoid heavy greases in tight thrust positions.

When should both bearings be replaced?

Replace both thrust bearings if one shows wear or roughness to ensure balanced axial control and consistent drivetrain geometry after service.