Tamiya GT-01 Precision Camber-Adjustable Titanium King Pin Ball Stud GT-11 by 3Racing  [GT-11]

Tamiya GT-01 GT01 Titanium Camber Adjustable King Pin Ball Stud - 3RACING GT-11
Price:
USD$7.50
Brand:
3Racing
Model:
GT-11
Condition:
Brand New
Write a review

Technical overview of the GT-11 camber stud

The GT-11 is a direct-fit, camber-adjustable titanium ball stud designed for the Tamiya GT-01 steering knuckle and king pin assembly. It replaces the standard stud to provide a stiffer, more repeatable pivot point intended for fine suspension setup and consistent front camber control.

Use this stud where predictable geometry and lower component compliance improve turn-in and mid-corner stability. The adjustability allows systematic changes to static camber and roll centre without swapping bulkhead or knuckle hardware, aiding setup development and repeatable lap-time testing.

Assembly notes: the stud is sized for GT-01 stock knuckles. Install using the original fasteners, apply suitable thread-locking compound, and follow recommended torque practices for small-scale RC components. Confirm thread engagement and clearance, and adjust camber incrementally while recording results for tuning fidelity.

What inspection should be done before fitting?

Check knuckle bore for wear, confirm thread pitch and stud length match the GT-01 standard, and ensure mating surfaces are free from burrs for precise seating.

Any torque guidance for installation?

Use the vehicle's documented small-fastener torque values where available and apply a medium-strength thread-lock; avoid over-torquing to prevent stripping the knuckle threads.

How to validate camber setup changes?

Record baseline camber, make single-step adjustments, and run controlled laps while monitoring tyre temperature and wear to correlate handling changes with camber values.