3RACING TS-GT01/V1 Titanium Screw Set for Tamiya GT-01 - Racing Grade Hardware  [TS-GT01/V1]

Tamiya GT-01 GT01 Titanium Screw Set - 3RACING TS-GT01/V1
Price:
USD$32.50
Brand:
3Racing
Model:
TS-GT01/V1
Condition:
Brand New
Write a review

Racing tuned titanium fasteners for Tamiya GT-01

The 3RACING TS-GT01/V1 set is engineered to replace factory fasteners on the Tamiya GT-01 with lightweight, high strength titanium hardware. This kit targets mass reduction at multiple chassis attachment points to improve transient response and balance.

Performance focused advantages

Titanium's superior strength to weight ratio reduces inertial load on moving components and helps maintain alignment under racing conditions. Use the kit to trim grams from rotating and suspended systems while keeping clamp integrity.

Fitment, installation and tuning notes

The kit matches common screw types used on the GT-01 platform for direct replacement. Install with correct driver sizes, verify seating for each head style, and recheck torques after initial runs. For competition setups, consider selective thread locker and systematic torque mapping across the chassis.

Which mounting points benefit most from titanium swaps?

Suspension mounts, body posts and certain hub fastenings often yield the best handling gains from weight reduction. Prioritise locations with rotating or suspended mass for maximum effect.

Any special installation procedure for racing use?

Use precision drivers, confirm proper head seating, and perform initial torque checks after a short run. For peak reliability, document torque values and revisit after heats to detect loosening trends.

How does titanium affect long term setup stability?

Titanium resists corrosion and retains strength, which supports consistent setup over time. Monitor for thread wear on mating components and replace or retap aluminium threads if necessary to maintain clamping accuracy.