3Racing M04M-03/0/LB Aluminium Rear Hub Carrier 0 Degree for Tamiya M03/M03L/M04M/M06 PRO  [M04M-03/0/LB]

Price:
USD$11.30
Brand:
3Racing
Model:
M04M-03/0/LB
Condition:
Brand New
Write a review

Performance oriented rear hub carrier from 3Racing M04M-03/0/LB

The 3Racing Aluminium Rear Hub Carrier provides a precision upgrade that targets improved rear assembly stiffness while maintaining the OEM 0 degree geometry. This component is intended for competitive hobbyists seeking consistent handling across repeated runs.

Precision engineering and material choice

Manufactured to tight tolerances, the aluminium carrier offers a stiffer mounting point than standard plastic parts. The 0 degree orientation ensures original suspension angles are retained, which helps preserve predictable suspension kinematics and tuning baseline for setup work.

Refit procedure and compatibility notes

The carrier is compatible with Tamiya M03, M03L, M04M and M06 PRO platforms that share the factory rear mounting interface. Installation follows OEM mounting points and requires basic hand tools; confirm hardware torque and use threadlocker where needed for sustained competition use.

Application and maintenance guidance

Ideal for drivers focusing on repeatable lap times, the aluminium carrier reduces flex that can alter feedback under load. Periodic inspection of mounting screws and bearing seats is recommended to ensure long term dimensional integrity.

What benefits does aluminium provide over stock plastic carriers?

Aluminium increases structural stiffness at the rear mounting point, which reduces deflection under load and helps maintain consistent geometry, improving repeatability during tuning.

Are there any recommended torque settings for installation?

Use the original service manual torque ranges where specified. If replacing plastic hardware with steel fasteners, avoid over-tightening to prevent thread damage; use medium strength threadlocker on steel screws in competition use.

Will this change cornering balance that requires suspension retune?

Because the part preserves 0 degree geometry, major balance shifts are unlikely. However, reduced rear flex can change feedback, so minor damping or toe adjustments may be used to fine tune handling.

Is any specific maintenance required for aluminium carriers?

Inspect mounting faces and fasteners regularly for wear or loosening. Clean mating surfaces and reapply threadlocker after periodic disassembly to maintain secure fitting in race conditions.