3Racing M04M-03/2/LB Technical Rear Hub Carrier for Tamiya M03/M03L/M04M/M06 PRO  [M04M-03/2/LB]

Price:
USD$11.30
Brand:
3Racing
Model:
M04M-03/2/LB
Condition:
Brand New
Write a review

Race Setup Notes

The 3Racing Aluminium Rear Hub Carrier M04M-03/2/LB is designed for precision tuning on Tamiya M03, M03L, M04M, and M06 PRO chassis. The 2-degree orientation provides a controlled change to rear geometry that racers can use to balance corner entry and exit behaviour.

Chassis Compatibility and Tuning

This carrier fits the listed Tamiya platforms and is suitable for drivers who want a predictable baseline for further suspension tuning. Use the 2-degree offset as part of a setup cycle to test roll center and traction changes under lap conditions.

Fitting and Alignment Procedure

Install the aluminium rear hub carrier with attention to torque values and component seating to prevent play. After fitting, assess toe and camber, then perform incremental setup tests to quantify handling gains.

How should I evaluate the effect of the 2-degree carrier?

Run controlled laps before and after fitting, noting changes in rear traction and corner exit stability. Adjust damping and roll stiffness to complement the geometry change.

Any specific hardware recommendations for installation?

Use the correct diameter screws and ensure they are tightened evenly. If using steel screws into aluminium, consider small amounts of thread locker and avoid overtorque to protect threads.

Will this part change suspension geometry significantly?

The 2-degree angle gives a modest but measurable change to rear geometry. It is intended as a fine tuning adjustment rather than a radical redesign.