Tamiya M03M Rear Hub Carrier 3 Degree Aluminium Race-Tune M03M-12/3/LB by 3Racing  [M03M-12/3/LB]

Tamiya M03M Aluminium Rear Hub Carrier 3 Degree - Light Blue Color - 3RACING M03M-12/3/LB
Price:
USD$11.30
Brand:
3Racing
Model:
M03M-12/3/LB
Condition:
Brand New
Write a review

Performance focused carrier note

This aluminium rear hub carrier is produced as a direct-fit upgrade for the Tamiya M03M chassis, finished light blue and configured with a 3 degree offset to alter rear geometry for race setups. It is intended to sit in the M03M rear hub area and deliver a discrete, repeatable change to rear-end behaviour during tuning sessions.

Installation follows a standard replacement routine: remove the factory rear carrier, align the replacement to the upright and suspension mounting points, and secure with the original chassis fasteners. After fitting, confirm wheel clearance and servo throw and validate handling through measured test laps.

From a tuning perspective the 3 degree carrier modifies rear toe/camber interplay, making it useful for drivers seeking finer control over rotation and exit traction. Use it as part of a setup plan alongside tyre selection and damper tuning to achieve consistent lap times.

Compatibility

  • Tamiya M03M

Is this suited to competitive tuning?

Yes, the carrier provides a controlled geometry change that teams can use to fine tune rear-end rotation and traction for specific track surfaces.

What setup areas should I review after fitting?

Re-evaluate rear toe, camber and damper settings, and perform lap tests to quantify changes before making further adjustments.

Any recommended test protocol?

Run controlled stints on your target surface, record handling notes and adjust one parameter at a time to isolate the carrier's effects.