Tamiya M03/M03L/M04M/FF02 Racing 64 Titanium King Pin - M04M-01 by 3Racing  [M04M-01]

Tamiya M03 /M03L /M04M /FF02 64 Titanium King pin - 3Racing M04M-01
Price:
USD$10.10
Brand:
3Racing
Model:
M04M-01
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Race-grade 64 titanium king pin for Tamiya chassis

Engineered for competitive setups, this 64 titanium king pin suits Tamiya M03, M03L, M04M and FF02 on-road platforms and is intended as a direct-replacement steering pivot. The focus is on consistent geometry and reduced wear to support repeatable lap-to-lap steering response.

In the front steering assembly the pin locates the upright and interfaces with the suspension link points. Fitment requires inspection of upright and stub axle free play, preservation of washer and bearing order, and verification of full steering travel with no binding. Use standard chassis fasteners unless specified otherwise by your kit or team setup.

From a tuning perspective this is a precision durability upgrade that helps maintain alignment and steering repeatability during intensive running. It is aimed at racers and tuners who prioritise consistent feedback and minimal maintenance drift on M03/M03L/M04M/FF02 based cars.

Will this alter steering geometry under load?

The part is dimensionally compatible with the stock pin; under load it reduces wear so the geometry remains stable rather than shifting with use.

Any special break-in or run-in procedure?

No special break-in is required; fit correctly, check for smooth articulation, and validate steering clearance at initial test runs.

Recommended checks between races?

Inspect the pivot for looseness or scoring, confirm bearing condition, and verify that steering geometry matches your setup notes before each race session.