3Racing M05-07/WO Technical Rear Suspension Pin Stiffener for Tamiya M05  [M05-07/WO]

Tamiya M05 Graphite Rear Suspension Pin Stiffener - 3RACING M05-07/WO
Price:
USD$3.80
Brand:
3Racing
Model:
M05-07/WO
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

3Racing M05-07/WO Rear Pin Stiffener Overview

The 3Racing M05-07/WO Graphite Rear Suspension Pin Stiffener is a focused upgrade for Tamiya M05 racers seeking crisper rear-end behavior. It increases lateral and torsional stiffness at the rear pin junction to reduce transient flex under load.

Performance and Tuning Considerations

Using graphite allows targeted stiffness without a significant mass penalty; this helps maintain front-end sensitivity while improving rear stability. When fitting, assess rear roll and adjust damping or spring rates to exploit the stiffer rear platform effectively.

Installation and Set Up Workflow

Install the 3Racing M05-07/WO into the stock rear pin locations of the Tamiya M05, securing all fasteners to the recommended chassis torque. Verify geometry after fitting and perform iterative test laps to dial in shock valving and toe settings for optimal balance.

How does the stiffener change chassis tuning?

It reduces rear compliance, so expect a firmer rear response; compensate with damping or spring adjustments to maintain front-rear balance for faster lap times.

Any setup tips for club tracks?

Start with a small increase in rear damping and a modest toe-in change, then refine based on corner entry understeer or oversteer tendencies.

Is this compatible with common hop-up uprights?

Compatibility is high with parts that preserve stock pin spacing; confirm clearances with offset or thicker uprights before final fitment.