3Racing M05-30/0/LB Rear Hub Carrier for Tamiya M05  [M05-30/0/LB]

Tamiya M05 Rear Aluminum Hub Carrier (0 Degree) - 3RACING M05-30/0/LB
Price:
USD$11.40
Brand:
3Racing
Model:
M05-30/0/LB
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Race-Focused Rear Hub Carrier for Tamiya M05

The 3Racing Tamiya M05 Rear Aluminium Hub Carrier is produced with racing setup priorities in mind. The aluminium construction reduces compliance at the upright interface and preserves a zero-degree toe setting under lateral loads, aiding consistent turn-in and exit behaviour.

Setup and Performance Notes

For tuners, fitting aluminium hub carriers lowers rotational flex that can mask suspension adjustments. Expect sharper feedback when evaluating toe and camber changes, which helps when iterating on small setup differences between runs.

Compatibility and Installation

This carrier is dimensioned to align with the Tamiya M05 mount points. Installation typically reuses the stock fasteners and wheel mounting hardware; verify bearing tolerances and clearances during assembly to ensure precise alignment.

How does aluminium affect tuning sensitivity?

Aluminium lowers component deflection, increasing sensitivity to suspension and toe adjustments. This can be beneficial for fine tuning but requires careful baseline setup.

Should I recheck toe after installation?

Yes. Confirm toe is set to your preferred specification since the stiffer carrier can subtly alter alignment compared with a plastic part.

Is this recommended for competitive racers?

For racers seeking predictable handling and improved part longevity, this aluminium carrier supports consistent setup validation and helps extract repeatable lap times.