Tamiya M07 Aluminium Rear Hub Precision M07-04 by 3Racing  [M07-04]

Tamiya M07 Aluminum Rear Hub - 3RACING M07-04
Price:
USD$13.90
Brand:
3Racing
Model:
M07-04
GTIN:
4895124756287
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Precision aluminium rear hub for M07

The 3Racing M07-04 aluminium rear hub is engineered for the Tamiya M07 chassis as a hop-up replacement for the OEM rear hub. Machined tolerances and the aluminium construction aim to provide predictable fit and repeatable performance when used in M07-series touring setups.

Installation notes: intended as a direct swap for compatible M07 rear hub assemblies. Verify bearing fit, mounting alignment and torque values during assembly. Retain or replace mounting hardware as needed to maintain correct preload and clearances.

Tuning considerations: the aluminium hub modifies rear-end stiffness and changes the distribution of loads into the rear suspension links and wheel bearings. Use this component when refining rear track, toe-in settings or when evaluating changes to transient response during handling tests.

Compatibility checks to perform before fitting

Confirm hub geometry against your existing carrier, check bearing inner diameter and ensure wheel hex alignment matches the replacement hub.

Recommended inspection after installation

After fitting, inspect bearing seating, fastener torque and wheel runout. Verify suspension articulation and recheck toe to confirm setup targets are met.

Effect on dynamic behaviour

Expect increased lateral stiffness at the hub which can tighten rear response under cornering; consider small incremental changes to roll balance when evaluating handling.