Tamiya 3RACING M4WD-44/WO Carbon Rear Multi Roller Plate - Race Tuning Spec  [M4WD-44/WO]

Tamiya Mini 4WD Carbon Rear Multi Roller Plate Base TZ - 3RACING M4WD-44/WO
Price:
USD$3.10
Brand:
3Racing
Model:
M4WD-44/WO
Condition:
Brand New
Write a review

Technical overview of the rear roller plate

The Tamiya Mini 4WD Carbon Rear Multi Roller Plate Base TZ by 3RACING M4WD-44/WO is engineered for competitive setups where rear geometry repeatability matters. The carbon construction gives a stiff mounting base suited to precise roller alignment and consistent handling feedback.

Performance tuning and chassis integration

Designed for racers, this rear multi roller plate optimises roller placement and helps maintain intended contact patches during high speed cornering. It integrates with common Tamiya Mini 4WD chassis to allow systematic tuning of rear behaviour.

Practical racebench adjustments

The plate supports quick, repeatable adjustments so you can test damping and roller offsets efficiently. Its design aims to reduce setup variability, helping teams reach consistent lap times across sessions.

What chassis interface points are used for mounting?

The plate uses standard rear mounting locations found on most Tamiya Mini 4WD platforms, allowing predictable fitment with minimal adapter hardware.

How should I approach roller alignment for race setups?

Begin with neutral offsets and document changes incrementally; small shifts in roller position can significantly alter corner exit behaviour and rebound.

Are there recommended torque settings for mounting screws?

Use low to moderate torque to secure hardware without crushing carbon; verify torque after initial runs to avoid loosening under vibration.