Tamiya 3RACING M4WD-48/SG Silver Carbon Surrounding Set - 3Racing Performance Upgrade  [M4WD-48/SG]

Tamiya Mini 4WD Silver Carbon surrounding set - 3RACING M4WD-48/SG
Price:
USD$10.70
Brand:
3Racing
Model:
M4WD-48/SG
Condition:
Brand New
Write a review

Technical Overview of the Silver Carbon Surround

The Tamiya 3RACING M4WD-48/SG Silver Carbon Surrounding Set is engineered to add structural support where chassis flex most affects handling. This component is intended for racers and tuners who prioritise predictable response under braking, cornering and acceleration.

Compatibility and Engineering Details

Manufactured to fit common Tamiya Mini 4WD chassis configurations, the surround uses a lightweight carbon laminate to reinforce critical attachment points. The geometry focuses on limiting torsional deformation while minimising added mass.

Tuning Impact and Setup Considerations

Integrating this surround can tighten handling and enable more aggressive motor and gear selections without losing control. Tuners can use the added rigidity to refine suspension geometry, tyre compound choice and weight distribution for specific track demands.

Installation and Service Notes

Professional alignment during installation ensures the surround delivers consistent benefits; check fastener torque and mating surfaces for repeatable results. Routine inspection after sessions helps maintain optimal performance.

Which chassis mounting points are reinforced by this surround?

The surround reinforces primary chassis attachment zones and load transfer pathways to reduce localised flex that affects steering and stability.

How does added stiffness change tuning priorities?

With reduced chassis compliance, tuners can focus on fine tuning gear ratios and tyre selection rather than compensating for unpredictable flex, allowing more precise setup adjustments.

Are any special fasteners or spacers required?

Standard Mini 4WD hardware is typically sufficient, but ensure correct spacer use to maintain intended load distribution and avoid point loading.

What inspection routine is recommended after racing?

Inspect fasteners for loosening, check for edge damage on the carbon and verify that mounting surfaces remain true after a few running sessions.