Tamiya PRO Touring Rear Hub Carrier 1 degree M04M-03/1/LB by 3Racing  [M04M-03/1/LB]

Price:
USD$11.20
Brand:
3Racing
Model:
M04M-03/1/LB
Condition:
Brand New
Write a review

Race-oriented 1 degree rear hub carrier for Tamiya PRO platforms

This 1 degree aluminium rear hub carrier in light blue anodise is intended for precision setup work on Tamiya M03, M03L, M04M and M06 PRO chassis. As a direct replacement carrier, it provides a small, consistent change to rear geometry that is useful when chasing balanced handling in competitive on-road setups.

The carrier shifts the hub mounting angle by exactly one degree relative to stock hubs, delivering a subtle, predictable tuning step. Use it to test incremental adjustments to rear camber and toe without removing other suspension components, making it suitable for methodical setup sessions and club-level competition.

Installation follows standard hub carrier replacement procedures: remove the OEM carrier, reassemble the rear upright and drive components in the same positions, and verify clearance and driveline alignment. After fitting, check wheel alignment and perform controlled test laps to assess the effect on handling. This product is intended for RC vehicles only.

What is the tuning intent of a 1 degree carrier?

A one degree change is a fine tuning step to alter rear grip and turn-in behaviour subtly, useful for incremental setup adjustments during testing.

Will this require other setup changes?

Expect to recheck suspension geometry and possibly adjust toe or camber to complement the new hub angle; keep changes small and test between runs.

Any fitment or clearance checks recommended?

Verify hub and tyre clearance, confirm axle engagement and ensure no binding in the driveline after installation; perform short test runs before competitive use.