Tamiya T3-01 12mm Hex Hub 7mm Offset Tuning Part - T301-02 by 3Racing  [T301-02]

Tamiya T3-01 12mm Hex Wheel Hub 7mm Offset - T301-02
Price:
USD$6.30
Brand:
3Racing
Model:
T301-02
Condition:
Brand New
Write a review

Precision Wheel Hub Adapter for T3-01

This hub adapter is an aftermarket tuning component for the Tamiya T3-01 chassis, featuring a 12mm hex mount and a 7mm offset to manipulate wheel lateral position. It is intended for measured setup changes to track width and scrub radius when refining handling and balance.

Fitment is aimed at experienced tuners: remove the wheel and original hub, position the 12mm hex adapter onto the T3-01 axle or stub, and secure with the existing wheel nut or retainer. After installation, verify there is no interference with suspension links or bodywork and confirm wheel runout and fastener torque during initial track checks.

Use this adapter for incremental tuning to influence corner entry, mid-corner balance, and tyre contact behaviour. Treat it as an aftermarket setup item and inspect mount security and fitment before each session.

What checks should a tuner perform after fitting?

Confirm full hex engagement, verify axial play is within acceptable limits, inspect clearance to suspension and body, and re-torque fasteners after a brief run.

How does the offset interact with steering geometry?

A 7mm lateral shift alters scrub radius and track, which can change steering sensitivity and tyre scrub; use it alongside toe and camber adjustments for balanced results.

Recommended use cases for this adapter?

Apply when tuning cornering balance, addressing asymmetric tyre wear, or when minor wheel relocation is needed to correct geometry on the T3-01 platform.