3RACING TA05-26 Tamiya TA05 Aluminium Swing Shaft Racing Pair  [TA05-26]

Tamiya TA05 Aluminium Swing Shaft ( 1 Pairs ) - 3RACING TA05-26
Price:
USD$13.90
Brand:
3Racing
Model:
TA05-26
Condition:
Brand New
Write a review

3RACING TA05-26 precision swing shaft for Tamiya TA05 setups

The 3Racing Aluminium Swing Shaft is engineered for tuners who demand consistent suspension behaviour from the TA05 platform. As a direct-replacement pair, these shafts aim to tighten control inputs and provide a predictable pivot under corner loads.

Technical benefits of aluminium in the swing shaft

Aluminium reduces compliance at the suspension linkage while maintaining a low mass that helps rotational dynamics. This combination improves steering crispness and makes fine setup changes more effective on track.

Installation and setup considerations

Installation is a simple swap into the existing TA05 suspension locations. For best results, inspect pivot interfaces, confirm axial clearance, and verify torque settings after the initial run to maintain repeatable behaviour.

Use in competitive tuning

These shafts are best applied where drivers are adjusting corner entry and mid-corner balance. They support setup adjustments by offering a firmer reference point for damper and anti-roll tuning.

Will these affect adjustability during setup?

Yes, the reduced flex gives clearer feedback when you change damper or anti-roll settings, making it easier to dial in handling characteristics.

Are there any clearance checks to perform?

Confirm that the swing shafts clear nearby components throughout travel and ensure bearings or bushings sit correctly to avoid side loading.

How should I validate performance gains?

Use timed runs and consistent track conditions to compare before and after behaviour. Note differences in turn-in, mid-corner stability, and tyre wear to assess the upgrade.