Tamiya TA05 Series Nylon Pivot Ball - TA05-10PB by 3Racing  [TA05-10PB]

Tamiya TA05 TA05-R Nylon Pivot Ball - 3RACING TA05-10PB
Price:
USD$1.90
Brand:
3Racing
Model:
TA05-10PB
Condition:
Brand New
Write a review

Technical pivot ball for TA05 steering systems

This nylon pivot ball is specified for TA05 and TA05-R steering linkages and carries the part number TA05-10PB. It is produced as an aftermarket service item to restore steering joint tolerance and reduce play in worn link assemblies.

Installed at the steering linkage and mount points, the nylon compound offers a practical balance of wear resistance and low sliding friction against common metal link pins. It is intended for routine replacement and light setup work rather than heavy duty or extreme racing stress.

Standard installation requires removal of the old pivot ball, cleaning of contact faces, and pressing the replacement into the linkage mount. After fitting, technicians should verify linkage geometry and free travel across the full steering arc. No additional components are supplied with the unit.

Recommended for service maintenance and accurate restoration of steering feel on TA05 family models; this is a model-scale replacement component only.

What tolerances should I expect from this pivot ball?

The part is manufactured to consistent dimensional tolerances for direct fit in TA05 linkage sockets; check for play after installation and replace if clearance exceeds acceptable service limits.

Any recommended maintenance for longevity?

Periodic cleaning of mating surfaces and light lubrication with a dry-friendly product will extend service life; avoid heavy oil that attracts grit.

Is this suitable for upgraded steering geometries?

Yes, it is compatible with common TA05 steering setups and can be used in tuned link arrangements, subject to correct alignment and periodic inspection.