3Racing TA05-05/SG Graphite Rear Stiffener Technical Upgrade for Tamiya TA05  [TA05-05/SG]

Tamiya TA05 TA-05IFS TA05-R Graphite Rear Stiffener - 3RACING TA05-05/SG
Price:
USD$12.60
Brand:
3Racing
Model:
TA05-05/SG
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical Rear Stiffener for Competitive TA05 Setups

The 3Racing TA05-05/SG Graphite Rear Stiffener is engineered to strengthen the rear torsional stiffness of the Tamiya TA05 chassis. Its graphite construction reduces chassis compliance at the rear bulkhead, improving repeatability of handling through a variety of cornering loads.

Performance Impact and Tuning Notes

Increasing rear stiffness alters load transfer characteristics, which can make steering response more linear and allow finer tuning of damper and anti roll bar settings. Use incremental changes and log setup differences when evaluating lap time impacts.

Fitting Procedure

Install with standard hand tools and verify secure seating at the mounting points. After initial runs, re-torque fasteners and inspect for even load distribution. This helps maintain consistent performance and prevents progressive loosening under race loads.

Which TA05 variants are supported by this part?

Designed for TA05 platform variants that share the rear mounting architecture, including TA05, TA-05IFS and TA05-R configurations.

How should I adapt suspension after fitting?

Expect to reassess roll stiffness and damping; often a slight reduction in rear roll stiffness or minor damping adjustment will rebalance handling after increasing chassis stiffness.

Any routine inspection points?

Check mounting screws and mating surfaces for wear or deformation after hard sessions. Confirm that the stiffener remains seated with no cracks or delamination.