3Racing TA05-03/SG Technical Graphite Rear Shock Tower for Tamiya TA05  [TA05-03/SG]

Technical Rear Bulkhead Upgrade for TA05 Chassis

Engineered for the Tamiya TA05 platform, including TA05, TA05-IFS and TA05-R, the 3Racing TA05-03/SG SSG graphite shock tower increases rear bulkhead rigidity to stabilise suspension pick up. The precision cut graphite panel improves structural integrity while keeping unsprung and sprung mass minimal for tuning-sensitive setups.

Graphite Material and Handling Impact

Graphite delivers a high stiffness to weight ratio that reduces chassis compliance at the shock mounts. This change tightens rear end response, allowing finer tuning of anti squat and damping without introducing excess weight.

Fitment, Mounting and Setup Considerations

The TA05-03/SG is produced to match OEM mounting geometry for direct replacement. Install with existing fasteners and verify shock and link geometry after fitting to preserve intended roll centre and camber behaviour.

Track Focused Upgrade for Competitive Setups

For racers optimising balance and consistency, this 3Racing graphite tower supports repeatable suspension operation under race conditions and assists in keeping setup changes predictable session to session.