3RACING TA05-07/S Titanium 4.75mm Ball Connector Set for Tamiya TA05  [TA05-07/S]

Tamiya TA05 TA05-R 64 TI 4.75mm Ball Connector Set ( 6 pcs ) - 3RACING TA05-07/S
Price:
USD$9.50
Brand:
3Racing
Model:
TA05-07/S
Condition:
Brand New
Write a review

Precision Linkage Upgrade for TA05 Platforms

The 3RACING 64 Ti 4.75mm Ball Connector Set provides a direct-fit titanium solution for the Tamiya TA05 and TA05-R linkage points. These connectors are intended to maintain consistent joint alignment and predictable control inputs under competitive running conditions.

Technical Highlights of the TA05-07/S Set

Each connector in the TA05-07/S set is titanium, chosen to combine high tensile strength with minimal added mass. The 4.75mm ball dimension matches TA05 linkage standards, facilitating straightforward replacement without altering geometry or link length.

Recommended Use and Setup Considerations

Use these connectors when aiming for repeatable steering behaviour and reduced linkage wear. Inspect attachment points for correct thread engagement, apply appropriate thread locking where metal-to-metal contact occurs, and verify free movement through full steering travel before track running.

Will these maintain geometry during high load maneuvers?

Titanium connectors resist deformation under load better than many stock materials, helping to preserve linkage geometry during aggressive inputs. Proper installation is critical to avoid preloading the joints.

Any setup tips for minimal binding?

Ensure ball stud threads are clean and seat fully. Confirm the ball sits squarely in the socket throughout steering travel and check for any interference at full lock to prevent binding.

What maintenance schedule do you recommend?

For competitive use inspect connectors after each meeting, check for play, and replace if wear is detected. Apply a light, dry-compatible lubricant on moving surfaces during routine service to reduce abrasive wear.