Tamiya TA05-R RR 1 Degree Rear Aluminum Suspension Mount - 3RACING  [TA05-11/1/LB]

Tamiya TA05 TA05-R Rear Aluminum Suspension Mount (RR/1 Degree) - 3RACING TA05-11/1/LB
Price:
USD$7.60
Brand:
3Racing
Model:
TA05-11/1/LB
Condition:
Brand New
Write a review

Race-Oriented 1 Degree Rear Mount for TA05-R

Specifically for competitive setups on a Tamiya TA05 or TA05-R chassis, the 3RACING RR 1 degree rear aluminum suspension mount offers a consistent reference point for tuning. Its design supports predictable rear geometry under dynamic loads to assist lap time optimisation.

Technical Advantages for Tuning

Machined aluminium provides more stable pivot points than molded alternatives, helping maintain alignment during lateral loads. The 1 degree inclination is a tuning increment aimed at improving rear traction modulation without large setup shifts.

Integration and Installation Notes

The mount is produced to match TA05 and TA05-R factory mounting locations for a direct replacement. Fit using standard hex hardware and verify alignment after installation as part of a structured setup routine.

How does the 1 degree mount interact with roll centre adjustments?

The 1 degree mount alters the toe and traction characteristics subtly; when combined with roll centre changes you should re-evaluate antiroll bias and shock valving to maintain balance.

Are there recommended inspection points after races?

Check mount flatness, mounting screws and adjacent composite parts for cracks. Verify that pivot clearances remain within acceptable limits to prevent handling drift.

Can this be used with aluminium uprights and hubs?

Yes, it integrates with aluminium uprights and hubs that retain TA05 mounting geometry. Ensure pin spacing and bearing alignment remain correct during assembly.