Tamiya TA05/FF03 Servo Mount Upgrade TA05-14/V2/LB by 3Racing  [TA05-14/V2/LB]

Tamiya TA05 FF03 Aluminum Servo Mount - Ver. 2 - 3RACING TA05-14/V2/LB
Price:
USD$7.60
Brand:
3Racing
Model:
TA05-14/V2/LB
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Servo mounting upgrade for TA05/FF03 chassis

The TA05-14/V2/LB is a version 2 aluminium servo mounting plate designed to fit Tamiya TA05 and FF03 mounting patterns.

As a chassis-specific upgrade component, it substitutes the factory servo bracket on compatible frames to reduce flex at the servo interface and provide a firmer attachment point when the original mounting locations are used.

Installation note: supplied as the mount only. Confirm included fasteners with the vendor before beginning assembly. Check servo horn centring and linkage geometry during installation to ensure correct neutral position and full travel.

Technical role: the mount is used to stabilise the mechanical support of the servo assembly; a stiffer mounting surface can reduce interface movement and help maintain predictable steering behaviour during suspension compression and high load scenarios.

What must I check for correct fitment?

Confirm the chassis uses the same servo mounting hole spacing as the TA05/FF03 pattern and ensure the mount sits flush to the chassis bulkhead before tightening hardware.

Are there recommended fastener sizes?

Fastener requirements vary by chassis; refer to the vehicle manual or seller notes for screw length and thread size to avoid interference with internals.

How does this affect setup tuning?

A firmer servo mounting point can change steering response and is often used alongside servo position and linkage adjustments to fine tune steering precision for competition or club runs.