3RACING TA05-IF04 Titanium Ball Stud Set for Tamiya TA05-IFS  [TA05-IF04]

Race-Grade Titanium Ball Studs for TA05-IFS

The 3RACING TA05-IF04 titanium ball stud set is engineered for competitive TA05-IFS builds where repeatable steering geometry and lower unsprung mass matter. Machined titanium components reduce deflection at the joint and extend service life compared with standard hardware. These studs are appropriate for drivers refining suspension balance and response.

Material and Handling Advantages

Titanium provides a superior strength to weight ratio that helps maintain consistent camber and toe under high loads. The reduced inertia at pivot points improves transient response, aiding quick direction changes and precise corner entry.

Fitment and Setup Guidance

The TA05-IF04 studs are produced to match TA05-IFS thread and seat dimensions for direct installation. Confirm thread engagement depth and initial torque, then validate settings during a controlled test run. For high mileage track use, inspect mating cups and replace if signs of wear appear to preserve joint accuracy.