3Racing 415-01/1X Aluminum Suspension Mount for Tamiya TA05-R/TRF415/TRF-416 Racing Spec  [415-01/1X]

Tamiya TA05-R /TRF415 /TRF-416 Aluminium Suspension Mount (1X) - 3Racing 415-01/1X
Price:
USD$5.00
Brand:
3Racing
Model:
415-01/1X
Condition:
Brand New
Write a review

Race-oriented 3Racing 415-01/1X aluminium suspension mount

Engineered for use on Tamiya TA05-R, TRF415, and TRF-416 platforms, the 3Racing 415-01/1X Aluminum Suspension Mount replaces factory mounts to lower compliance and sharpen feedback. The design focuses on predictable responses important for lap-to-lap consistency in competitive environments.

Precision fit and application

The mount aligns with original mounting interfaces and is intended to work with standard Tamiya geometry. Reduced flex improves shock performance fidelity and helps maintain setup settings under repeated track loads.

Installation and setup guidance

Install using calibrated hand tools and check fastener torque values to avoid distortion. After installation, confirm suspension travel and wheel alignment, then perform incremental setup changes to tune handling for your racing surface.

What changes in chassis stiffness should I expect?

Expect a measurable reduction in local flex at the suspension pick-up points, resulting in a firmer steering response and more repeatable corner entry behaviour.

Any special tools needed for precise installation?

Standard metric hex drivers and a torque driver are sufficient. Use a torque driver for critical fasteners to ensure even clamp load and avoid distortion of the mount.

How should I integrate this into race setup changes?

Treat the aluminium mount as a platform change; baseline your setup after fitting and make small adjustments to camber and toe to optimise tyre contact and steering balance for your track conditions.