3RACING BS-415/V1 Bearing Set for Tamiya TRF 415  [BS-415/V1]

Tamiya TRF 415 Ball Bearing Set - 3RACING BS-415/V1
Price:
USD$13.50
Brand:
3Racing
Model:
BS-415/V1
Condition:
Brand New
Write a review

3RACING BS-415/V1 Bearings: Precision Fit for TRF 415

The 3RACING BS-415/V1 kit supplies bearings sized for the Tamiya TRF 415 mounting points, aimed at lowering drivetrain friction and improving mechanical efficiency. Correct bearing selection reduces parasitic losses across gears and shafts.

Performance Advantages for Race Setup

Upgrading to ball bearings cuts rolling resistance and improves torque transfer consistency. That helps reduce drivetrain hysteresis and supports more predictable handling through acceleration and braking phases.

Fitment Notes and Installation Best Practice

Bearings should be pressed squarely on the outer race and checked for axial play. Confirm shaft runout and coupling alignment after fitting to avoid preload or binding that would negate performance gains.

Value and Tuning Potential from 3RACING

3RACING parts are designed to offer measurable setup improvements without extensive chassis modification. The BS-415/V1 set integrates into typical TRF 415 tuning workflows as a cost effective friction reduction upgrade.

What tolerance checks are recommended after fitting?

Verify radial and axial play, ensure no binding at full suspension travel, and confirm gear mesh under load to make sure bearings sit correctly in the Tamiya TRF 415 assembly.

Can bearing choice influence differential behaviour?

Yes, lower bearing drag reduces parasitic losses that affect differential preload and response; check diff feel after installation and adjust tuning accordingly.

Recommended service interval for competitive use?

Service frequency depends on conditions, but inspect bearings between race days and clean or replace them if you detect roughness, contamination, or increased play.