3Racing 416-03/LB Rear Bulkhead for Tamiya TRF 416 - Race Setup Component  [416-03/LB]

Tamiya TRF 416 Rear Bulkhead - 3RACING 416-03/LB
Price:
USD$12.60
Brand:
3Racing
Model:
416-03/LB
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Race Oriented 3Racing Rear Bulkhead for TRF 416

The 3Racing 416-03/LB is a dedicated rear bulkhead developed to improve the rigidity of the Tamiya TRF 416 chassis. Manufactured with close tolerances to ensure consistent fitment, it is intended for drivers who refine handling through chassis stiffness adjustments.

Technical Benefits

Replacing the standard rear bulkhead with the 3Racing unit reduces rear flex and stabilises suspension pivot points under load. This aids in predictable toe and camber behavior, allowing more precise tuning of roll center and anti-squat characteristics for competitive setups.

Installation and Setup Notes

During installation, use calibrated torque settings for fasteners and confirm driveline alignment to avoid binding. After fitting the 3Racing bulkhead, re-evaluate rear shock valving and spring rates to match the increased chassis stiffness on the Tamiya TRF 416.

What setup changes are recommended after fitting?

With reduced flex expect to lower rear ride frequencies slightly and adjust shock damping to maintain rear grip through mid corner transition.

Is additional chassis bracing required?

In most cases the 3Racing bulkhead provides sufficient rear reinforcement; further bracing depends on driver preference and track conditions.

Material and manufacturing tolerances?

The part is produced to tight tolerances to ensure repeatable geometry; verify fit before final assembly and confirm no interference with drivetrain components.