Tamiya TT-01 Type-E Front Bumper & Battery Socket TT01-M02 by 3Racing  [TT01-M02]

Tamiya TT-01 Type-E Option Replacement Plastic Front Bumper & Battery Socket Set - 3RACING TT01-M02
Price:
USD$2.50
Brand:
3Racing
Model:
TT01-M02
Condition:
Brand New
Write a review

Precision replacement for front nose and battery mount

This technical replacement set delivers a plastic front bumper and battery socket engineered for the Tamiya TT-01 Type-E chassis. It provides a direct-fit solution to replace compromised nose components and the battery mounting interface while preserving original chassis geometry and mounting points.

Fitment is specific to the TT-01 Type-E configuration; verify the chassis code prior to purchase. The swap is a standard service-level operation that uses the existing TT-01 Type-E mounting bosses and typically reuses factory screws and brackets for a clean installation.

For maintenance and setup work, the components restore body alignment and battery retention after contact incidents, contributing to predictable handling and consistent setup repeatability during practice and race events. Note that these plastic parts prioritise correct fit and weight savings rather than structural reinforcement.

What chassis checks should I perform before fitting?

Confirm the TT-01 Type-E designation and inspect the existing mounting points for wear. Replace any stripped screws before installing the new bumper and battery socket.

Are any setup changes needed after replacement?

If the replacement restores original alignment, no setup changes are required. Verify body alignment and battery position, then perform a short test run to confirm handling is consistent.

Can this be used with tuned suspension setups?

Yes, the part maintains the stock mounting geometry so it is compatible with common suspension tuning changes; ensure battery placement remains secure for weight balance considerations.