3RACING TT01-M08 Foam Bumper for Tamiya TT-01 Type-E - Racing Fitment  [TT01-M08]

Tamiya TT-01 Type-E Option Replacement Foam Bumper - 3RACING TT01-M08
Price:
USD$2.50
Brand:
3Racing
Model:
TT01-M08
Condition:
Brand New
Write a review

3RACING TT01-M08 Front Impact Bumper for Tamiya TT-01 Type-E

Engineered for compatibility with the Tamiya TT-01 Type-E, the 3RACING TT01-M08 foam bumper offers a simple impact management solution. The part is intended to absorb contact energy at the nose without altering core chassis geometry.

Compatibility and Fitment Details

The TT01-M08 aligns with the TT-01 Type-E factory mounting positions to ensure consistent mating with the chassis. Proper seating and correct fastener torque are recommended to maintain effective energy transfer and repeatable protection.

Service and Installation Recommendations

Install the 3RACING bumper by removing the existing front bumper from the Tamiya TT-01 Type-E, positioning the TT01-M08, and reinstalling original hardware. Inspect the foam and fasteners after initial runs and following impacts to confirm continued fit and function.

What should I check during a post-impact inspection?

Verify that the bumper remains seated against the mount points and that fixings are tight. Check the foam for compression or tearing that could reduce protective performance.

Are any modifications required for standard TT-01 Type-E bodies?

No chassis modifications are required for standard TT-01 Type-E shells. Fitment should be verified on any car with non-stock body mounts or custom brackets.

How often should the foam bumper be replaced in race conditions?

Replace the bumper if it shows significant deformation or damage after impacts, or if it no longer holds securely to the mount points during inspection.