Traxxas Revo Low-Profile Steering Saver Mount RE-033/S by 3Racing  [RE-033/S]

Traxxas Revo Steering Saver Mount - Silver - 3RACING RE-033/S
Price:
USD$8.21
Brand:
3Racing
Model:
RE-033/S
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Technical Notes on Revo Fitment

This saver mount is a direct-fit aftermarket component for the Traxxas Revo chassis, engineered to position a steering saver assembly while retaining the original mounting geometry for predictable alignment.

Positioning the saver with this mount diverts impact forces and sudden steering loads into the saver assembly rather than transmitting them to the servo and primary steering links, improving steering consistency under competitive or demanding use. The silver finish is intended to match common Revo aesthetic choices.

Installation requires standard RC workshop tools and is performed by replacing the original mount at the factory mounting points. Where applicable, the existing screws and link hardware can be reused, simplifying installation and reducing the need for additional fasteners.

In a tuning context, the mount facilitates repeatable changes to steering compliance by allowing rapid swapping of saver units and link geometries, so you can tune how much energy is dissipated before the servo engages with the load.

What alignment checks are recommended after fitting?

Verify steering centring, travel and that the saver assembly moves freely through its range without binding. Confirm the saver geometry directs loads away from the servo horn.

Can I reuse the original fasteners?

The design uses factory mounting points and typically allows reuse of the original screws and link hardware, but confirm thread sizes and lengths before final assembly.

How does this affect tuning options?

By providing a stable, repeatable mount location for saver units, it makes it easier to test different saver stiffness and link geometries to control when the servo begins to sense impact loads.