Traxxas Revo SSG Graphite Brake Disc RE-015A by 3Racing  [RE-015A]

Traxxas Revo SSG Graphite Brake Disc - 3RACING RE-015A
Price:
USD$6.82
Brand:
3Racing
Model:
RE-015A
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Performance graphite rotor for Revo SSG

Engineered as a racing-oriented replacement rotor for Traxxas Revo SSG platforms, this graphite disc is intended for hobbyists tuning braking characteristics. The material selection targets consistent pad interaction and a stable wear profile under repeated deceleration cycles.

Use the rotor as a direct service replacement or as part of a setup change to refine braking modulation on race or trial runs. Verify hub interface dimensions and rotor runout during installation to maintain predictable braking behavior.

Technical fitment steps: remove wheel and prior rotor per service protocol, inspect hub hardware and bearing tolerances, mount the graphite disc with concentric alignment, and rotate to measure clearance. Use calibrated torque settings on fasteners to preserve bearing preload and thread integrity.

Compatibility matrix

  • Compatible with Traxxas Revo SSG

What inspection checks ensure correct fitment?

Measure hub bore, rotor thickness and bolt pattern; check for concentric mounting and acceptable runout. Address any deviation before full-speed testing.

How should I verify rotor runout?

Rotate the mounted assembly and use a dial indicator or careful visual check at low speed to confirm minimal lateral wobble; shim or re-seat if required.

Recommended procedure after fitment?

Perform incremental speed tests, monitor pad contact and temperature build-up, and recheck fastener torque after initial runs to ensure stable performance.