TRF 415 CNC-Style 1A Ver.2 Suspension Mount 415-01/1A/V2 by 3Racing  [415-01/1A/V2]

Tamiya TRF 415 Option Aluminium Suspension Mount (1A) - Ver. 2 - 3RACING 415-01/1A/V2
Price:
USD$5.00
Brand:
3Racing
Model:
415-01/1A/V2
Condition:
Brand New
Write a review

Technical 1A Ver.2 aluminium mount for TRF 415

The 415-01/1A/V2 is a machined aluminium 1A Ver.2 suspension mount intended as a direct replacement for the pickup point on the Tamiya TRF 415 chassis. Designed to reduce local compliance, the component delivers a firmer pivot and consistent geometry for setup repeatability.

As an upgrade part the mount replaces the stock link attachment and mates to existing suspension links and fasteners without chassis modification. The stiffer interface helps maintain alignment under dynamic loads, improving the predictability of tuning changes.

Installation follows standard procedures: remove the OEM 1A mount, align the new part to the chassis holes and secure with suitable hardware. After fitting verify suspension travel, camber and toe, then validate handling with incremental setup adjustments.

Tuning note: because the aluminium pickup alters local stiffness, evaluate changes to shock damping and anti-roll balance to achieve the desired transient and mid-corner behaviour.

What is the intended use for this mount?

This mount is for track-focused setups where a repeatable, low-compliance pickup point is required to fine tune handling.

Any special fitting considerations?

Use correct torque settings and check fastener condition; aluminium changes load paths so fastener security is important for longevity and consistent geometry.

Recommended tuning approach after fitting?

Adopt a systematic approach: make one change at a time to dampers or anti-roll devices and document lap times to quantify the effect of the stiffer pickup.