TRF 416 Racing Knuckle Arm 416-18/LB by 3Racing  [416-18/LB]

Tamiya TRF 416 Aluminium Knuckle Arm - 3RACING 416-18/LB
Price:
USD$12.50
Brand:
3Racing
Model:
416-18/LB
Condition:
Brand New
Write a review

Precision knuckle for TRF 416 setups

This CNC-grade aluminium knuckle arm from 3Racing is supplied as model 416-18/LB and is intended as a high-value aftermarket replacement for the TAMIYA TRF 416 knuckle. The component retains OEM mounting locations and suspension geometry while providing a stiffer hub mounting interface for more repeatable steering feedback.

For competitive setup work the knuckle performs two core functions: it secures the wheel hub and steering linkages to a rigid surface and it stabilises suspension geometry during iterative tuning. When installed on a TRF 416 chassis, the part allows finer evaluation of camber, toe and damper changes because mounting points are unchanged and material stiffness is consistent.

Installation guidance: fit as a direct swap into the TRF 416 using the chassis' existing fastener points. Adhere to published torque values and assembly order, verify linkage geometry and wheel hex concentricity, and run controlled test runs to confirm expected handling adjustments.

Which TRF 416 submodels are supported?

The knuckle is manufactured to match the TRF 416 standard knuckle footprint and is intended for direct replacement across TRF 416 variants that use the same mounting pattern.

How does aluminium stiffness affect setup tuning?

Aluminium reduces flex at the hub relative to plastic, which can tighten steering feedback and alter corner entry behaviour; expect to re-evaluate camber and toe to optimise tyre contact patch under dynamic load.

What pre-checks are recommended before track testing?

Confirm fastener torque, steering linkage geometry, wheel hex seating and bearing play. Perform a short low-speed run to validate alignment before full-speed tuning sessions.