TRF Aluminium Suspension Mount Ver. 2 - 415-01/B1X/V2 by 3Racing  [415-01/B1X/V2]

Technical aluminium suspension mount for TRF chassis

This Ver. 2 aluminium suspension mount, designated 415-01/B1X/V2, is an aftermarket hop-up engineered for Tamiya TRF 415, FF03, TA-05IFS and TRF-416 chassis families. The component replaces the moulded plastic mount to provide a more rigid suspension pick-up anchor suitable for precise setup work.

The part emphasises tuning stability rather than geometry change, providing reduced compliance at pivot points and improved long term durability compared with stock parts. It is intended for hobbyists and competitive tuners seeking consistent roll centre behaviour and repeatable adjustments.

Installation is a direct-fit into original screw positions using donor hardware. During assembly confirm thread insert condition, torque screws with the appropriate hex driver, and validate toe and camber measurements after installation to ensure alignment targets are maintained.

As an anchor for upper and lower links, expect tighter control over roll behaviour between runs and the ability to make finer shock and anti-roll bar adjustments with reduced interference from mount flex.