TT-01 Rear Aluminium Hub Carrier 1 Degree Precision Upgrade - TT01-12/1/LB by 3Racing  [TT01-12/1/LB]

Tamiya TT-01 /TT-01 TYPE E Rear Aluminum Hub Carrier (1 Degree) - 3Racing TT01-12/1/LB
Price:
USD$11.30
Brand:
3Racing
Model:
TT01-12/1/LB
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Precision aluminium rear hub carrier for TT-01

Developed as a direct aluminium replacement for TAMIYA TT-01 and TT-01 TYPE E chassis, this 1 degree offset hub carrier provides predictable toe change while maintaining OEM spindle compatibility. The component improves mounting rigidity at the hub, reducing deflection under lateral loads and supporting consistent toe settings during competitive running.

Confirm chassis hub layout matches the listed TT-01 variants before fitting. The CNC-like finish and aluminium construction deliver a stiffer interface than stock plastic carriers, which helps preserve alignment and reduces the need for frequent retuning after impacts.

Installation uses the stock wheel spindle and original fasteners following usual TT-01 procedures. After assembly, verify bearing seating and suspension geometry; even a single degree offset can affect corner entry and mid-corner balance and should be dialled in with small toe adjustments to suit each setup.

What is the intended use case for this carrier?

Engineered for on-road and club racing where precise toe control and repeatable handling are required, the carrier suits drivers looking to fine tune rear traction with minimal chassis change.

Does the part require reworking before installation?

No machining is normally necessary for standard TT-01 or TT-01 TYPE E layouts. Fit using the OEM spindle and hardware, then verify alignment and torque specifications.

Recommended setup checks after fitment?

After fitting, check bearing play, wheel alignment at ride height, and perform incremental toe adjustments to assess handling changes introduced by the 1 degree offset.