TT-01 Rear Aluminium Hub Carrier 3 Degree TT01-12/3/LB by 3Racing  [TT01-12/3/LB]

Precision rear hub carrier for TT-01 platforms

Engineered as an aftermarket aluminium replacement for 1/10-scale Tamiya TT-01 and TT-01 TYPE E chassis, this carrier establishes a fixed 3-degree rear camber to facilitate predictable rear-end behaviour during competitive tuning. It is intended to interface with standard rear suspension mounts on these platforms.

Manufactured from aluminium to reduce flex relative to stock plastic parts, the carrier provides a rigid mounting surface for the rear hub and suspension link attachments, improving consistency under dynamic loads.

Fitment guidance: inspect the TT-01 or TT-01 TYPE E rear knuckle and mounting arrangement for compatibility prior to installation, reuse the vehicle's existing fasteners and wheel bearings unless undertaking a bearing or hardware upgrade, and verify drive-shaft engagement and wheel alignment following installation. The part is supplied without assumption of additional hardware.

Tuning considerations: the fixed 3-degree camber alters lateral tyre contact under load and will affect cornering balance and wear patterns; integrate this component into an iterative setup process focusing on rear toe, damper rates, and anti-roll balance for best results.