TT-01 Rear Racing Hub Carrier 0 Degree - TT01-12/0/LB by 3Racing  [TT01-12/0/LB]

Tamiya TT-01 /TT-01 TYPE E Rear Aluminum Hub Carrier (0 Degree) - 3Racing TT01-12/0/LB
Price:
USD$11.30
Brand:
3Racing
Model:
TT01-12/0/LB
Condition:
Brand New
Write a review

Technical Overview - Rear Hub Carrier for TT-01

This aluminium rear hub carrier is engineered as a direct-replacement for Tamiya TT-01 and TT-01 TYPE E rear knuckles, designated TT01-12/0/LB. It provides a stiffer mounting point intended to tighten rear suspension response for competitive setups.

Fitting requires standard TT-01 disassembly: remove the rear knuckle, install the aluminium carrier, and refit existing axle hardware. Maintain original mounting geometry and use common hex tools; ensure bearings are seated correctly to avoid unwanted preload or binding.

On-track, a metal carrier reduces compliance at the knuckle and can sharpen consistency through cornering transitions. Pair this unit with matched bearings and considered wheel offsets when aiming for repeatable lap times and predictable handling adjustments.

What bearing sizes are recommended when upgrading?

Use the stock bearing sizes unless you are switching to precision sealed bearings for lower friction; verify internal clearance after fitting to avoid preload.

Does this affect toe or camber settings?

The carrier itself keeps stock geometry but changes in stiffness can alter suspension behaviour; expect to fine-tune toe and camber for optimum performance after installation.

Is additional reinforcement needed for high-strain racing conditions?

The aluminium carrier improves durability over plastic, but inspect adjacent suspension links and consider uprated mounting hardware for high torque or heavy-impact use.